DL3MC APRS Map

☰

reset

SP2OSA-2 Telemetry

This is the latest recevied telemetry packets stored in our database for station/object SP2OSA-2. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).

Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).

<< 1 2 >>

Time	TX*	RX*	Digi*
1782002936	776 Count	72 Count	63 Count
1781996630	769 Count	72 Count	63 Count
1781995729	768 Count	72 Count	63 Count
1781993927	766 Count	72 Count	63 Count
1781989423	761 Count	72 Count	63 Count
1781988522	760 Count	72 Count	63 Count
1781986720	758 Count	72 Count	63 Count
1781982236	753 Count	72 Count	63 Count
1781981335	752 Count	72 Count	63 Count
1781980434	751 Count	72 Count	63 Count
1781979533	750 Count	72 Count	63 Count
1781974128	744 Count	72 Count	63 Count
1781972326	742 Count	72 Count	63 Count
1781971425	741 Count	72 Count	63 Count
1781966020	735 Count	72 Count	63 Count
1781965119	734 Count	72 Count	63 Count
1781963317	732 Count	72 Count	63 Count
1781961537	730 Count	72 Count	63 Count
1781958834	727 Count	72 Count	63 Count
1781957933	726 Count	72 Count	63 Count
1781957032	725 Count	72 Count	63 Count
1781956131	724 Count	72 Count	63 Count
1781950726	718 Count	72 Count	63 Count
1781949825	717 Count	72 Count	63 Count
1781948924	716 Count	72 Count	63 Count

*Used Equation Coefficients:

TX: 0, 1, 0

RX: 0, 1, 0

Digi: 0, 1, 0

V_Bat: 0, 0.01, 0

V_Ext: 0, 0.02, 0

The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value² + b * value + c.
The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)

Maintained by DL3MC, based on APRS Track Direct