This is the latest recevied telemetry packets stored in our database for station/object LW2DHT-3. If no packets are shown the sender has not sent any telemetry packets the latest 1 day(s).
Telemetry packets is used to share measurements like repeteater parameters, battery voltage, radiation readings (or any other measurements).
| Time | TX* | RX* | Digi* | V_Bat* | V_Ext* |
|---|---|---|---|---|---|
| 1778095083 | 139 Count | 160 Count | 105 Count | 0 VDC | 0 VDC |
| 1778089673 | 126 Count | 147 Count | 95 Count | 0 VDC | 0 VDC |
| 1778087870 | 120 Count | 141 Count | 90 Count | 0 VDC | 0 VDC |
| 1778084262 | 112 Count | 132 Count | 84 Count | 0 VDC | 0 VDC |
| 1778082458 | 107 Count | 126 Count | 80 Count | 0 VDC | 0 VDC |
| 1778077093 | 95 Count | 111 Count | 71 Count | 0 VDC | 0 VDC |
| 1778073485 | 87 Count | 102 Count | 65 Count | 0 VDC | 0 VDC |
| 1778071681 | 84 Count | 98 Count | 63 Count | 0 VDC | 0 VDC |
| 1778069877 | 81 Count | 95 Count | 61 Count | 0 VDC | 0 VDC |
| 1778060858 | 59 Count | 72 Count | 44 Count | 0 VDC | 0 VDC |
| 1778059055 | 55 Count | 67 Count | 41 Count | 0 VDC | 0 VDC |
| 1778057252 | 50 Count | 62 Count | 37 Count | 0 VDC | 0 VDC |
*Used Equation Coefficients:
TX: 0, 1, 0
RX: 0, 1, 0
Digi: 0, 1, 0
V_Bat: 0, 0.01, 0
V_Ext: 0, 0.02, 0
- The parameter names for the analog channels will be Value1, Value2, Value3 (up to Value5) if station has not sent a PARAM-packet that specifies the parameter names for each analog channel.
- Each analog value is a decimal number between 000 and 255 (according to APRS specifications). The receiver use the telemetry equation coefficientsto to restore the original sensor values. If no EQNS-packet with equation coefficients is sent we will show the values as is (this corresponds to the equation coefficients a=0, b=1 and c=0).
The sent equation coefficients is used in the equation: a * value2 + b * value + c. - The units for the analog values will not be shown if station has not sent a UNIT-packet specifying what unit's to use.
- The parameter names for the digital bits will be Bit1, Bit2, Bit3 (up to Bit8) if station has not sent a PARAM-packet that specifies the parameter names for each digital bit.
- All bit labels will be named "On" if station has not sent a UNIT-packet that specifies the label of each bit.
- A bit is considered to be On when the bit is 1 if station has not sent a BITS-packet that specifies another "Bit sense" (a BITS-packet specify the state of the bits that match the BIT labels)